Jumper Wire (跳线)
Dimension T-TYPE:
|
Unit: mm
|
|||||||||||||||||||||
|
||||||||||||||||||||||
DIMENSION P-TYPE |
Unit: mm
|
|||||||||||||||||||||
|
||||||||||||||||||||||
DIMENSION P-TYPE
|
Unit: mm
|
|||||||||||||||||||||
|
TEST
|
TEST METHOD
|
LIMITS
|
RESISTANCE | *<0.005 ohm | |
OPERATING TEMPERATURE | *-55 ~ +155℃ | |
MAX. CURRENT | *5.amps | |
MAX. WORKING VOLTAGE | *300 Vdc | |
MAX. OVERLOAD VOLTAGE | *600 Vdc | |
TEMPERATURE COEFFICIENT | *(PPM/℃) 0 ~ -100PPM | |
SHORT TIME OVERLOAD | *Apply 2.5 times the voltage rating for 5 sec | No VISIBLEDAMAGE |
LOAD LIFE | *1.000 hrs. at 70 ℃ a direct voltage applied ℃,and cyclesof 1.5 hrs. *on and 0.5 hrs. off throughout test |
△R =0.5% |
TEMPERATURE CYCLING | *5 cycles of 30 min. duration at the extremes of temprange. value 4 hrs. *Maximum and minimum,measurement of ohmic *after completion of test |
△R =0.5% |
DIELECTRIC STRENGTH | *Using a 95 ℃ ”V” shaped conductive block apply 100V ℃minimum. *increasing 100V/sec. for 5 sec |
△R =0.5% |
HUMIDITY | *350hrs.at 40℃.90 ~ 95% Rh | 95% of TESTED |
SOLDERABILITY | *Dipped in Sn/Pb (60/40) at 235。,5 sec. 1.5mm from the body | SURFACE/COVERED |
VIBRATION | *By JIS-5012-C5033 | |
TERMINAL ROBUSTNESS | *Traction,applied 2.5kg. for 10 sec. Bends. 2 bends 90℃ applying load to terminals of 0.5kg. Twist.2 ℃successive turns 180°,6mm from body | |
RESISTANCE T0 SOLVENTS | *Trichlorethylene,TMC as the most aggressive for 60 sec. *at boiling point. |
NO VISIBLEDANACE |